On-Road IoT
-
CR100 CAN devices now support a single output that can be assigned a peripheral to control an external relay. Additionally, events such as idling, over-speeding, and towing will now include the full duration of the event, not just the start time.
-
The CANiQ-M device is now available for use in On-Road IoT at a level 3 integration. Users can point their CANiQ-M devices directly to On-Road IoT to configure and control output peripherals, view CAN signals including DTCs, and monitor CAN-based events.
-
Electric assets associated with a MyGeotab platform account will display EV data in the Electric Fleet Operations Dashboard, such as State of Charge, Remaining Range, Energy Efficiency, and more. Electric vehicles must be assigned per vehicle within On-Road IoT.
-
Send Immobilizer and Limp Mode remote commands directly to Orbcomm ST6100 and ST9100 devices. Read Send commands to the mobile device.
-
Added the ability to manually set Odometer and Engine Hours on Orbcomm ST6100 and ST9100 devices. See Set odometer and engine hours values on the Orbcomm devices.
-
Columns in the new Configuration groups page can now be reordered by clicking and dragging in the column chooser. Read how in Move columns on the Configuration groups page.
EasyCheck - vehicle inspections mobile app
- Notifications can be sent when critical issues are resolved or when vehicles report fault codes, with alerts configurable by status and severity.
Knowledge base updates
Set the odometer value for an asset
1. Make the CANiQ device available
2. Set up CANiQ devices in On-Road IoT
1. Make the Orbcomm devices available
2. Set up Orbcomm devices in On-Road IoT
Set odometer and engine hours values on the CalAmp devices
Set odometer and engine hours values on the Orbcomm devices
Send commands to the mobile device
Why are there empty EV columns on the Electric Fleet Dashboards
Move columns on the Configuration groups page
View the health status of an onboard computer