Skip to main content
Employee Sign in

Default events supported on CR400

Marisa Potgieter
  • Updated

If default events were added after you made the mobile device available, you must manually add the newly added events for it to display in the event template. 

  • In On-Road IoT, click Manage.
  • Under Config admin, click Templates.
  • Look for the Default event template for CR400 CAN.
EventEvent type
* Harsh CorneringSystem
Asset TowedExternal
Driver AuthenticatedExternal
Driving Without AuthenticationExternal
End of trip fuel tank level percentageSystem
External Battery Back To NormalExternal
External Battery LowExternal
Harsh accelerationSystem
Harsh brakingSystem
Idle - excessiveSystem
Impact DetectExternal
Input 1 ActiveExternal
Input 1 InactiveExternal
Input 2 ActiveExternal
Input 2 InactiveExternal
MiX Vision: Driver distractionMiX Vision
MiX Vision: Driver fatigue - eye closingMiX Vision
MiX Vision: Driver fatigue - yawningMiX Vision
MiX Vision: Driver not wearing seatbeltMiX Vision
MiX Vision: Driver smokingMiX Vision
MiX Vision: Event video requests cappedDiagnostic
MiX Vision: Following distance warningMiX Vision
MiX Vision: Forward collision warningMiX Vision
MiX Vision: GPS lossMiX Vision
MiX Vision: Impact detectionMiX Vision
MiX Vision: IO1MiX Vision
MiX Vision: IO2MiX Vision
MiX Vision: IO3MiX Vision
MiX Vision: IO4MiX Vision
MiX Vision: IO5MiX Vision
MiX Vision: IO6MiX Vision
MiX Vision: IO7MiX Vision
MiX Vision: IO8MiX Vision
MiX Vision: Lane departure warningMiX Vision
MiX Vision: Lens coveredMiX Vision
MiX Vision: Low voltageMiX Vision
MiX Vision: Manual alertMiX Vision
MiX Vision: Mobile phone distractionMiX Vision
MiX Vision: Motion detectionMiX Vision
MiX Vision: No driverMiX Vision
MiX Vision: Pedestrian collision warningMiX Vision
MiX Vision: Power lossMiX Vision
MiX Vision: Storage exceptionMiX Vision
MiX Vision: Video lossMiX Vision
Over speedingSystem
Speed detected during ignition offExternal
Tamper detectedExternal

Note: These events are only used for data processing and event thresholds cannot be changed or set on the device from the config page. 

ODOMETER

The device will send an odometer value but odometer values cannot be set in On-Road IoT. 

Related articles