Skip to main content
Sign in

Default events supported on CR100

Marisa Potgieter
  • Updated

[[#Default events]]

[[#Odometer]]

[[#CAN data exposed as events]]

Default events

If default events were added after you made the mobile device available, you must manually add the newly added events for it to display in the event template.

  1. In On-Road IoT, click Manage.
  2. Under Config admin, click Templates. * Look for the Default event template for CR100 CAN.
  3. Click on the template name to view the events.
Event Event type
* Harsh Cornering System
Asset Towed External
Driver Authenticated External
Driving Without Authentication External
End of trip fuel tank level percentage System
External Battery Back To Normal External
External Battery Low External
Harsh acceleration System
Harsh braking System
Idle - excessive System
Impact Detect External
Input 1 Active External
Input 1 Inactive External
Input 2 Active External
Input 2 Inactive External
VisionAI: Driver distraction VisionAI
VisionAI: Driver fatigue - eye closing VisionAI
VisionAI: Driver fatigue - yawning VisionAI
VisionAI: Driver not wearing seatbelt VisionAI
VisionAI: Driver smoking VisionAI
VisionAI: Event video requests capped Diagnostic
VisionAI: Following distance warning VisionAI
VisionAI: Forward collision warning VisionAI
VisionAI: GPS loss VisionAI
VisionAI: Impact detection VisionAI
VisionAI: IO1 VisionAI
VisionAI: IO2 VisionAI
VisionAI: IO3 VisionAI
VisionAI: IO4 VisionAI
VisionAI: IO5 VisionAI
VisionAI: IO6 VisionAI
VisionAI: IO7 VisionAI
VisionAI: IO8 VisionAI
VisionAI: Lane departure warning VisionAI
VisionAI: Lens covered VisionAI
VisionAI: Low voltage VisionAI
VisionAI: Manual alert VisionAI
VisionAI: Mobile phone distraction VisionAI
VisionAI: Motion detection VisionAI
VisionAI: No driver VisionAI
VisionAI: Pedestrian collision warning VisionAI
VisionAI: Power loss VisionAI
VisionAI: Storage exception VisionAI
VisionAI: Video loss VisionAI
Over speeding System
Tamper detected External

Note: These events are only used for data processing and event thresholds cannot be changed or set on the device from the config page.

Odometer

The device will send an odometer value. Set the odometer value in the mobile device settings of the asset. Read Set the odometer value for an asset

CAN data exposed as events

  • Server-side processing of additional CAN data is supported on theCR100 Cellocator device. This enables monitoring of low fuel level or state of charge, EV charger status, high engine coolant temperature, seatbelt status, and door status (up to four doors).

Processed as server-side events - these events are not part of the default template and must be added optionally

  • Fuel Level Low 2

  • State of Charge

  • EV CAN: Charger Status

  • Over revving

  • Engine Coolant Temperature High 2

  • Driver seatbelt not engaged

  • Driver door open

  • Passenger door open

  • Passenger side rear door open

  • Driver side rear door open

Related articles