The VAC will display arrows pointing left and right to indicate communication between the iPort controller and the IDSY hardware. In addition;
- If the trucks iBasic, iAlert & iControl are enabled, the tech should see iP settings in the config section of the truck. If those aren’t there, then the passkeys have not been enabled.
- There have been times where new rucks arrive that should have had those pre-enabled, but were missed due to the way the sales person placed the order. In that case, they simply supply the Sales Order for the truck so the factory can verify it was, in fact, ordered and they will just give the techs the passkeys.
Relay State Unknown may be caused by the sequence you are performing (be sure key is on key)
The init Speed must be set to zero and the error speed set to 1mph.